– 14 –
.28..CORRECTING.THE.CLOTH.SLIPPAGE
1. If the lower cloth is longer than the upper cloth at the sewing end, turn the top feed adjusting
dial counter clockwise ("–" direction).
2. If the upper cloth is longer than the lower cloth at the sewing end, turn the top feed adjusting
dial clockwise ("+" direction).
★
.Shirring
To perform shirring, use a B-type (rake-in type) gauge, and set the top feed amount at a large
value by turning the top feed adjusting dial clockwise (toward "+" direction).
(Caution). When.the.top.feed.amount.is.set.to.4.mm.or.more,.operate.the.machine.at.3,500
sti/min.or.less.
.29..ADJUSTING.THE.PRESSURE.OF.THE.WALKING.FOOT
Depress adjusting screw
1
, when turned clockwise, the pressure of the walking
foot increases, and when turned counterclockwise, the pressure decreases.
The standard pressure (4.5 to 5 kg) is obtained by loosening the fully tightened
adjusting screw about 6 turns.
The graduation of the adjusting screw provide standard values suitable for in
individual materials when turning in adjusting screw
1
.
(Caution). Take.care.not.to.excessively.increase.the.walking.foot.pressure.
or.set.the.presser.foot.pressure,.otherwise.the.presser.foot.for.
presser,.otherwise.the.presser.foot.will.float,.leading.the.insuf-
ficient.feed.power.
Model
Description
Industrial Sewing Machine
Function
make stitches and sew
MH-380 Series,MH-480 Series
vii
DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINERY
We hereby declare that the sewing machine (sewing head) described below ;
1. Must not be put into service until the machinery to which it is incorporated has been declared in
conformity with the provisions of the Directive 2006/42/EC, and
2. Conforms to the essential requirements of the Directive 2006/42/EC, described in the technical
documentation, and
3. To be prepared with the above technical documentation compiled in accordance with part B of
Annex VII, and
4. Also to conform to the RoHS Directive 2011/65/EU
5. Relevant information on which should be transmitted in response to a reasoned request by the
national authorities, by the electronic method or other according to the request.
Applied harmonized standards, in particular :
EN ISO12100, EN ISO10821, EN 50581
Manufacturer :
JUKI CORPORATION
2-11-1, Tsurumaki, Tama-shi, Tokyo, Japan
Summary of Contents for MH-486-5
Page 2: ......
Page 27: ... 17 33 TROUBLES AND CORRECTIVE MEASURES ...
Page 29: ... 19 ...
Page 31: ......
