-16-
-16-
-16-
-16-
-16-
4-17 Super stitch pattern
1. Select the hemming pattern and perform a trial sewing.
2. Check that the needle enters into the same needle entry holes of the left-side in
forward/backward stitches.
3. Insert a screwdriver into the small hole of the bottom cover and turn the adjusting
screw.
Super stitch pattern opens Turn the adjusting screw clockwise.
Super stitch pattern overlaps Turn the adjusting screw counterclockwise.
4. After performing the adjustment, check also “4-16 reverse stitch” and “4-19 button
hole”.
How to adjust
Hole for adjustment
Adjusting screw
4-18 Height and position of the presser foot
Remove the face plate.
1. Set the presser foot for zigzag stitch, and when the presser foot lever is raised,
loosen the setscrew of the presser bar guide and move the presser bar up or down
so that the presser foot is 6 mm above the upper face of the throat plate.
[2.5 mm hexagon screwdriver]
2. At this time, determine the rotating direction of the presser bar so that the groove of
the feed dog is parallel to the presser foot.
* Place screwdriver of 6 mm shaft dia. under the presser foot when the feed dog is
lowered and move the presser bar up or down. The screwdriver is available as a
substitute of the gauge. (Standard value: 6.0 + 0.5/0 mm)
How to adjust
6 mm
Needle entry
holes
Under side cover
ø 6 screwdriver