ENGLISH
6
■
As-fitted picture of tape attachment
6
How to detach a carrier tape
(1) Detach the cover tape from the tension roller, and cut it
with scissors.
When replacing the tape reel halfway, press the idler arm to
attach it next time. Pull out the cover tape from the space of
gear by some 15 mm, and cut its end with scissors.
(2)
Open the upper cover, and detach the cover tape from the slit.
(3)
Pull the carrier tape.
(4)
Pull the tape from the lane.
7
How to discard a cover tape
(1) Discard the cover tape when the chamber lid begins to open.
(2)
Extract the cover tape, and cut it near the cover tape
discharging slot.
At this time, do not pull the cover tape strongly.
8
How to use a pick position cap (PP cap)
The PP cap attached on the upper cover at the factory is to be used for
components whose sizes are shown on the right side.To place a
component other than those components on a board, remove the PP cap
from the upper cover, and then store it in the storage section of the grip.
*To prevent the setscrew of the PP cap from being lost, leave it fixed on
the upper cover when the PP cap is removed.
CAUTION
Regarding the other ETF models, mount and
dismount a tape by using the “Feeder setup stand for
Electric feeder” when EF08HD is adjacent at
preparation in the feeder bank or Feeder trolley.
Guide 15 mm
Feeder setup stand for Electric feeder
Storage section
of the grip
Components for which the PP cap is used
0603 / 1005 / 1608
PP CAP
Setscrew
Upper Cover
To attach the PP cap on the upper
cover, push it gently in the direction
indicated with the arrow mark.
Push the PP cap with a finger along
the groove into the storage section
of the grip.
Storage section
of the grip
