– 21 –
6. List of memory switches
(1) User level
When
key is held pressed for two seconds or more with the sewing machine started, the memory
switches can be set.
Every time one memory switch is changed, the changed value is stored in memory by pressing
key.
Parameter
code
Description of parame-
ter
Range
Initial
value
Explanation of the content represented by the value
001.H
Maximum sewing speed 100 to 2200
2200
sti/min
Setting of the maximum number of revolutions while
the sewing machine is in operation
Depending on the minimum sewing speed No. 60
002.PSL
Adjustment of accelera-
tion curve
30 to 100
80%
Setting of the percentage of rise of acceleration
003.NUD
Selection of home
position of needle when
the sewing machine is
stopped
UP/DN
UP
UP (upper stop position) / DN (lower stop position)
004.N
Sewing speed at the
start of reverse feed
stitching
100 to 2200
1200
sti/min
Setting of the sewing speed to be employed at the
start of reverse feed stitching
005.V
Sewing speed at the
end of reverse feed
stitching
100 to 2200
1200
sti/min
Setting of the sewing speed to be employed at the end
of reverse feed stitching
006.B
Sewing speed of over-
lapped stitching
100 to 2200
1200
sti/min
Setting of the sewing speed to be employed at the end
of overlapped stitching
007.S
Soft start speed
100 to 2200
400
sti/min Setting of the soft start speed
008.SLS
Number of stitches for
the soft start
0 to 99
Two
(stitches) Setting of the number of stitches for the start start
009.A
Sewing speed for con-
stant-dimension sewing
100 to 2200
1500
sti/min
Setting of the sewing speed to be employed when the
AUTO key on the operation panel box is pressed
010.ACD
Function to automati-
cally finish reverse feed
stitching after sewing of
the constant-dimension
sewing (compensation
stitching function is not
set)
ON/OFF
ON
ON: The sewing machine carries out sewing of the
constant-dimension sewing for the last step, and au-
tomatically performs reverse feed stitching and stops.
Because of this operation sequence, compensation
stitching function cannot be used before finishing re
-
verse feed stitching.
OFF: The sewing machine carries out sewing of the
constant-dimension sewing for the last step, and stops
without automatically performing reverse feed stitch-
ing. In this case, it is necessary to operate the pedal
again in order to carry out thread trimming. It should
be remembered, however, that compensation stitching
function can be used.
011.RVM
Selection of the mode
for reverse feed stitch-
ing
ON/OFF
ON
The reverse feed stitching switch:
ON: Operation is enabled both while the sewing ma-
chine is in operation and when it is at rest.
OFF: Operation is enabled on while the sewing ma-
chine is in operation.
012.SMS
Selection of reverse
feed stitching starting
mode
A/M
A
A: The sewing machine automatically carries out the
constant-dimension sewing operation when the pedal
is lightly depressed.
M: It is possible to select start or stop of the sewing
machine as desired depending on the depressing
depth of the pedal.