JUKI DSC-246, Instruction Manual

Page: 25 / 32

vi
BEFORE OPERATION
• Before you put the machine into operation for the fi rst time after the set-up, clean it thoroughly .
Remove all dust gathering during transportation and oil it well.
• Con
fi rm that voltage has been correctly set.
Con fi rm that the power plug has been properly connected to the power supply.
• Never use the machine in the state where the voltage type is different from the designated one.
• The direction of normal rotation of the machine is counterclockwise as observed from the pulley side.
Take care not to allow the machine to rotate in the reverse direction.
• Never operate the machine unless the machine head and the oil tank have been
fi lled with oil.
• For a test run, remove the bobbin and the needle thread.
• For the
fi rst month, decrease the sewing speed and run the sewing machine at a speed of 2,000 sti/min or less.
• When carrying the machine, do not hold it by the synchronizer located at the rear of the handwheel.
• Operate the handwheel after the machine has totally stopped.
• Observe the standard thread trimming speed, 185 sti/min.
CAUTION :
Check the following so as to prevent maloperation of and damage to the machine.
– 15 –
21142302
(Caution) The parts attached with an asterisk ( * ) are the exclusive parts for the DSC-246-7.