– 20 –
4-8. Adjustment procedure for the pocket setting device
(1) Adjusting the pocket support plate
Pocket support plate
❺
can be adjusted in the direction
of arrow
❸
(angle adjustment) by loosening setscrews
❶
and
❷
.
In addition, it can be adjusted in the direction of arrow
❹
(horizontal direction) by loosening setscrews
❻
and
❼
.
(2) Adjusting the height of the pocket setting
plate
Adjust the clearance between the table and pocket set-
ting plate
❶
according to the type of material.
Place the material on the sewing table. Adjust the clear-
ance between the table and the pocket setting plate so
that the pocket support plate is brought to the top sur-
face of the material when the pocket setting plate is in
its lower end.
<Adjustment procedure>
1) Press
A
on the sewing screen to lift pock-
et setting plate
❶
. Press
B
to change the
mode from the automatic mode to the step mode
(
).
2) Loosen two nuts
❷
. Adjust, with stopper bolts
❸
,
the lift of the pocket setting plate
❶
.
3) Press the start button to lower the pocket setting
plate. Check the clearance between the top surface
of the table and the pocket support plate.
Reference height for adjustment: Adjust so that a
clearance through which a garment body is allowed
to pass is provided between the top surface of the
table and the pocket support plate.
4) After the adjustment of the clearance, tighten nuts
❷
with pocket setting plate
❶
held lowered. Then,
fix the nuts with stopper bolts
❸
.
5) In the aforementioned state, loosen sensor fixation
screw
❹
. Adjust the position of the sensor light so
that it lights up in this state. Then, tighten sensor
fixation screw
❹
.
6) Cancel the step mode and change to the automatic
mode.
❶
❷
Angle adjustment
❸
Travel adjustment
❹
❻
❼
Parts to be
changed
according to
the size
❺
A
B
❸
❷
❶
❹
Parts to be
changed
according to
the size
