– 6 –
3-3. Installing the panel
1) Open cover
❶
and remove cable
❷
once.
Then connect it again to the panel on the top
surface of the table after passing it through the
hole in the table.
2) Fix operation panel installing plate
❸
to an op-
tional place on the table with two wood screws
❹
.
Install the panel at the position where
X-move cover or head grip does not
interfere with it since breakage of the
panel will be caused.
1) Installing the IP-420
❹
❸
❶
❷
3-4. Installing the thread stand
1) Assemble the thread stand. Then, put it in thread-stand mounting hole
A
or
B
in the machine table.
2) Tighten locknut
❶
to fix the thread stand.
3) When ceiling wiring is possible, pass the power cord through spool rest rod
❷
.
4) If thread sags, use thread stand guide arm (asm.)
❸
.
❶
❷
❸
A
B
Table
