– 84 –
(4) When the pattern is changed
1) When X/Y enlargement/reduction ratio,
thread tension value, and intermediate
presser height of the data of the vector format
are changed, and
key is pressed, the
display is in the pattern No. selection state as
shown in the figure.
When you desire to change the pattern No.
in this state, the display becomes the pattern
No. change confirmation display.
When destroying the contents of the current
pattern and changing the pattern No., press
key, and when canceling the change
of pattern No., press
key.
In order to store the changed pattern, see
-3-3. Performing copying of pattern"
3-3. Performing copying of pattern
Copying below can be performed under the pattern copy mode.
• Copying from vector format data to users' pattern
• Copying between vector format data
• Copying from users' pattern to vector format data
• Copying between users' patterns
1) Confirm that sewing LED went out, and press
key.
Display the copy mode with
key or
key, and press
key.
2) First set No. of the copy source. Select the
pattern No. of copy source with
key or
key.
Here the registered vector format data, users'
pattern and the edited vector format data can
be selected.
When No. of the copy source is determined,
press
key to set No. of the copy
destination in the set state.
h
h
h
h
h
