JUKI AC-172N-1790, Instruction Manual

Page: 69 / 102

− 65 −
☆
Sewng data are those that can be nputted to 99 patterns from pattern 1 to 99 and can be nputted to
each pattern. The sewing machine has been set in the state that the data which is necessary to set “With/
without edit” cannot be selected at the time of your purchase. Change over the function to “With edit” if
necessary for the use.
/
Refer to "
@
-2-8. Method of setting sewing data with/without edit" p.64 .
* 1 : Displayed according to the shape.
* 2 : Displayed when it is set to with edit. Refer to
"
@
-2-8. Method of setting sewing data with/without edit" p.64 .
* 3 : Displayed when the function is selected.
2-9. Sewing data list
No. Item Settng range Edt unt Remarks
S01 Sewing shape
Ths tem selects the shape from among the sewng shapes of
30 dfferent knds whch the sewng machne has.
1 to 30 1 –
–
Refer to "
@
-2-6. Standard sewing
shape list " p.62 .
* Only 12 knds of standard sewng shapes can be selected
at the tme of your purchase. When ncreasng the knds
of shapes, perform settng of K04 Sewng shape selecton
level of memory swtch data.
/
Refer to "
@
-2-16. Memory switch data list" p.78"
S02 Cloth cut length
Ths tem sets the length of cloth that s cut by cloth
cuttng knfe. However, n case of bar-tack shape (Nos.
27, 28, 29, and 30 of S01), sewng length s set.
By makng effectve U19 Function of plural mo -
tions of cloth cutting knife of memory swtch data,
make the plural motons of knfe by the knfe sze set
n the tem U18 Cloth cutting knife size , and the
sewng product s cut.
/
Refer to "
@
-2-16. Memory switch data list" p.78"
3.0 to 120.0 0.1mm –
S03 Knife groove width, right
Ths tem sets the clearance between cloth cuttng
knfe and rght parallel secton.
–2.00 to 2.00 0.05mm –
S04 Knife groove width , left
Ths tem sets the clearance between cloth cuttng
knfe and left parallel secton.
–2.00 to 2.00 0.05mm –
S05 Overedging width, left
Ths tem sets the overedgng wdth of left parallel
secton.
0.10 to 5.00 0.05mm –
S06 Ratio of right and left shapes
Ths tem sets enlargement/reducton rato of rght
sde shape makng the knfe poston as the center.
50 to 150 1% –
S07 Pitch at parallel section
Ths tem sets sewng ptch of left and rght parallel
sectons.
0.200 to 2.500 0.025mm –
S08 2nd bar-tacking length
Ths tem sets length of bar-tackng on the front sde.
0.2 to 5.0 0.1mm –
Bottom
of taper
Bottom
of square
type
Bottom of
straight
bar-tacking
S09 1st bar-tacking length
Ths tem sets length of bar-tackng on the rear sde.
0.2 to 5.0 0.1mm –
Top of
square
type