– 49 –
If you press the cancel button on any of the screens
which appear on the steps of procedure beyond
3
,
the screen returns to the belt loop data entry screen.
In this case, the values of the parameters you have not
set shown on the belt loop data entry screen are their
initial values.
1
Displaying the data entry screen
Only on the belt loop ndvdual sewng data entry screen (blue),
the name of a belt loop pattern number can be entered. On
the sewng screen (green), press the set ready key
to
dsplay the data entry screen (blue).
2
Bringing up the character entry screen
When you press character entry button
A
, and the char-
acter entry screen s dsplayed.
3
Entering characters
Characters can be entered by pressng character button
B
correspondng to the desred character. As many as 14 alpha-
numerc characters ( to , to ) and symbols ( , ,
, and ). The cursor can be moved by means of cursor
leftward-travel button
C
or cursor rghtward-travel button
D
. If you want to delete the entered character, move the
cursor to the character to delete and press delete button
E
.
4
Finishing the entry of characters
When you press enter button
F
, the character entry s
finished. After the end of the character entry, the characters
you have entered are dsplayed on the upper part of the data
entry screen (blue).
It s possble to enter as many as 14 characters for each belt loop pattern number.
A
B
C
F
D
E
7
Finishing the creation of a new pattern
When you press close button
O
on the bartackng nfor-
maton entry screen, the screen goes back to the belt loop
data entry screen. Check to make sure that the parameters
you have set are ncluded on the data entry screen.
2-10. How to name a belt loop pattern number