Advanced Matrix Display (LCD Display) Instruction Manual
NDW
The NDW is the pedal assist level limiter. In the default configuration there are 5 modes
of pedals assist.
ECO, 1, 2, 3, and Sport
The maximum pedal assist level that can be selected can be adjusted by adjusting the
value of the ndw setting.
NDW setting
:
◦
The maximum assist level that can be selected is ECO
◦
The maximum assist level that can be selected is assist level 1
◦
The maximum assist level that can be selected is assist level 2
◦
The maximum assist level that can be selected is assist level 3
◦
The maximum assist level that can be selected is assist level SPORT
Torque
The Pedal Assist System is designed to provide you with motor assistance when you
pedal. The torque sensor setting allows you to choose if you want to use the torque
sensor measurement for the pedal assist. The torque sensor is on by default. In normal
operation, both the torque sensor and cadence sensor measurements will be used to
determine the pedal assist support level.
On:
The torque sensor will be activated and the pedal assist will factor in torque and
cadence measurements to determine the pedal assist support level.
OFF:
The torque sensor will be turned o
ff
and only the cadence sensor measurement
will be used to determine the pedal assist support level.
Low Volts
The low voltage setting controls how deeply the battery is allowed to discharge. The
lower this setting, the lower the battery is allowed to discharge.
Studies have shown that avoiding a deep discharge state can significantly increase
battery life. The low volts setting will set a limit to the lowest voltage that the System
will allow the pack to discharge.
When the motor draws power from the battery pack, the voltage of the battery will
decrease. When the voltage further decreases and reaches the preset limits, the control
system will automatically limit power so the voltage never decreases below this pre-set
limit.
Advanced Matrix Display (LCD Display) R2017-12-01
11
