DIMENSIONS (H x W x D Inches)............................................1.72 x 19.00 x 7.00
CHASSIS DESIGN............................................................Tour Class
(TM)
Unibody
WEIGHT (LBS)....................................................................................................11
CURRENT CAPACITY
RP100-15A..……………............................................................15
Amps
RP100-20A..……………............................................................20
Amps
VOLTAGE INPUT...........................................................................120 VAC, 60Hz
USB PORTS................................................................................5 VDC @ 500mA
POWER OUTLETS
Fifteen Amp Units..........................................................10 NEMA 5-15R
Twenty Amp Units.................................8 NEMA 5-15R, 2 NEMA 5-20R
POWER CORD
Fifteen Amp Units.............................7 Foot, 14/3 SJT with NEMA 5-15P
Twenty Amp Units............................7 Foot, 12/3 SJT with NEMA 5-20P
POWER METER
Voltage.....................................................0 to 240 VAC to nearest tenth
Amperage...................................................0.40 to 25.0 to nearest tenth
TRANSIENT ENERGY ABSORBTION...................................................300 joules
PEAK SURGE CURRENT (Line, Neutral & Ground)..............30,000 amps / mode
SPECIFICATIONS
FRONT PANEL
Combination On/Off Switch and Circuit Breaker
– The rocker switch
located on the right side of the chassis is a dual function component. It
is normally used to manually turn the RACKPOWER on and off. In the
event of a prolonged current load in excess of fifteen amps (twenty
amps on the 20A models) the circuit breaker will trip to shut off power.
(See the Troubleshooting section of this manual.)
.
AC Power Meter
- The dual function, digital meter uses red LEDs to
report power line voltage and the current load being drawn from the
RACKPOWER. A push button to the left of the meter toggles the meter
display between voltage and amperage. Voltage metering is displayed
to the nearest one tenth volt. Amperage is displayed to the nearest one
tenth amp through a range from 0.4 amps to 25.0 amps. The display
will flash as a warning when voltage is greater than 139VAC or amper-
age is greater than 13.9A (18.9A for the 20A model) are reached.
USB Power Port
- The USB connector on the front of the chassis pro-
vides 5 volts of DC current for use powering a plug-in LED light or for
charging an electronic device such as an MP3 player or cell phone.
This port is specially designed to charge iPhones and most other smart
phone models. (A USB Port is also located on the back of the chassis.)
AC Receptacle
- The AC receptacle on the left of the chassis is pow-
ered whenever the RACKPOWER is plugged into a live AC power
source. It is rated at 15 amps or 20 amps and provides all the AC power
protection of the RACKPOWER.
Surge Protection OK
- The RACKPOWER 100 features a replaceable
surge protection (RSP) module that includes three surge protection
components (MOVs). The white LED on the front panel is connected to
the primary MOV and is lit to indicate the surge protection components
are undamaged and functioning.
In the event of MOV damage due to
AC power line fault or due to excessive wear over an extended period,
that LED will no longer be lit, indicating surge protection may no longer
be working. Note: It is possible, but unlikely, the two secondary MOVs
are no longer protecting but the primary one is. In that case, the RSP
surge protector is still working, but with a lower capacity to sustain
power line surges. It is also possible that the primary MOV is no longer
functioning, causing the protection LED to go out while the two secon-
dary MOVs are still working. In either case, it is advisable to replace the
RSP. (See the Trouble Shooting section of this manual.)
