7
AUTO RETURN
ABSOLUTE CONTROL MODE
By pressing the “auto return”, the drone flies back in a straight line to the starting position: the
one that started the flight. To exit this mode, press the button again. When this function is ac-
tivated, the front lights remains fixed and the rear lights (blue) start flashing quickly. When you
switch the function, all the lights remains fixed.
During the standard flight, pressing the right lever to move the drone, identifies the direction
you should move with the direction of the front (left image). But when activated the absolute
control mode, pressing the corresponding button (center image), the drone flies ahead, regar-
dless of the orientation of the front (right image). For complete control, LED lights flash rapidly.
To make sure that the drone flies in a straight line, perform previously the calibration horizonta-
lity (read “Warnings” on page 4). Press the indicated button to exit this flight mode.
Auto return
Auto R
eturn
Start
End
Absolute
control
ATTENTION: If the drone crashes
into an obstacle during the flight, it
is possible to stop flying in a strai-
ght line and start flying laterally.
Land the drone and then reset the
calibration. For this, simultaneously
push both levers down and inside
diagonally of the control, as shown
in the picture on the right.
WARNING: Please note that the drone takes as reference the place that is was put during
taking off. If you fly the drone till it be places behind you, when you run the “auto return”, the
drone will move away, since it records the total displacement and return the distance recorded
according to the initial place.