Judo PROFIMAT JPF-A 1 1/2", Installation And Operating Instructions Manual

Page: 19 / 40

Remote control and remote transmission of messages
1701649 • 2019/04 JUDO JPF-A 19
1. Loosen the four screws of the cover and
remove the cover.
2. Perform settings on the DIP switch S2
acc. to Tab. 3: Setting the Potential-free
input.
3. Place the cover back on and bolt.
Function DIP switch S2 Description
external
backwash
start
Start backwashing
By closing a switching contact (brown and red wire) con-
nected to the potential-free input.
external
backwash
stop
When the switching contact at the potential-free input is
closed (brown and red wire).
Semi-auto-
matic
Relay 2 closes after the backwashing interval time has
elapsed or after the pressure has been exceeded at the
differential pressure sensor, thus indicating the request
for backwashing. At the same time the yellow “Backwash-
ing” LED flashes.
Backwashing can only be started with the manual switch
or on a switching contact connected to the floating input.
Incorrect
setting
Not permissible.
Continuous signal tone until the switch position is cor-
rected.
Setting the Potential-free input
6.2 Potential-free message
The device has an output for transferring
backwashing and fault indication messages
potential-free to a peripheral.
Fig. 9: Relay contact assignments