Operation
20
JUDO QUICKSOFT MEGA 4
5.7
Filling with salt
The water softening system works automat-
ically. Approximately 180 g of salt is needed
for each regeneration. The regenerating salt
must be replenished at regular intervals.
Our recommendation:
Broxo or Solvay
salt, either as blocks, tablets or coarse
grains 7 - 15 mm. If other regenerating salts
are used, then the salt reservoir
must be
cleaned at shorter intervals and the intake
strainer replaced more frequently.
The salt reserve should not decrease so far
that the liquid level is above the regenerat-
ing salt, as otherwise when replenishing the
salt, it rises excessively.
The regenerating salt is normally replen-
ished in sacks of 25 kg. This salt quantity is
sufficient for at least 120 regenerations.
5.7.1 Message upon low salt level
The salt concentration of the brine reservoir
is automatically regularly checked. If the salt
container is not topped up in time and the
brine concentration is too low, the display in-
dicates:
After this message, replenishment with a
quantity of 25 kg of regenerating salt is re-
quired. Then the <OK> key must be briefly
pressed. The warning message is then re-
set.
If the salt is only replenished once the salt
reserve is completely used up, the brine lev-
el may temporarily increase. The suction
process then lasts correspondingly longer.
If there is no longer any regenerating salt
available or if the regenerating salt is not re-
plenished early enough, the water softening
system switches to miser operation.
The remaining brine reserve is primarily
used for disinfection of the ion-exchange
resin, and the softening effect is reduced.
In this way, the water softening system re-
mains in a hygienic condition for weeks after
the low regenerating salt state first occurs.
This message can also appear if the
salting process is not performed cor-
rectly during regeneration, e.g. if the
waste water hose is routed at a too-
high level, if the mains water pres-
sure is too low or if the suction hose
connection to the salt/brine tank is
not made correctly.
Attention!
Salt deficit
Summary of Contents for 8200367
