JTS IN264R, Manual, Page: 5 / 8

2
IN
4
6
Music
INFINITY
Life
06 07
5. Operation
5-1 Set up the system
A)
Turn on the power of the receiver
Switch the “Power Switch” to “ON”. The “LCD Panel” and “REMOSET”
Key will light up.
B)
Turn on the power of the transmitter
Press the “Power Switch” . The “LCD Display” will light up.
C) Mute Function ( for IN264TH )
After the transmitter's power is on, short pressing the "Power Switch "
will mute the microphone. Press the "Power Switch" again will re-activate
the microphone.
Notice: You have to hold the "Power Switch" for 3 seconds in order to turn
off the transmitter.
D)
Install the antennas in a vertical position
5-2 Set up ID code
In order to match one receiver channel to one transmitter, IN264 is
designed with“ ID code”. If and only if both ID codes of a receiver channel
and a transmitter match each other, the “REMOSET” function works. When
setting the ID code, system will automatically avoid the ID code used by
the other channel. There are 100 ID codes available.
A) Press "Set" button for 3 seconds, LCD Panel will start flashing.
B) Press "Set" to enter "ID Code"
setting window. (Figure 2)
C) Press " Up" or Down" button to
select a distinct ID code from "id 0"
to "id 99".
D) After setting, press "Set" again to
save the setting.
2
5
4
17 24 12 18
1 6
3
17
Receiver
Handheld and BodyPack transmitter
ID code ON/OFF setting
A) Press "Set" button for 3 seconds, LCD Panel will
start flashing.
B) Press "Set" a couple of times until "ID Code ON/OFF" setting window shows.
C) Press " Up" or " Down" button to select between " ID ON " and " ID OFF ".
D) After setting, press "Set" again to save the settings.
Caution
When ID code is off (idOFF), the transmitter will accept any
synchronization from any IN264R.
ID code selecting
A) Press "Set" button for 3 seconds, LCD Panel will start flashing.
B) Press "Set" a couple of times until "ID Code" setting window shows.
C) Press " Up" or " Down" button to select a
distinct ID code from " id 0" to "id 99 ". (Figure 3)
D) After setting, press "Set" again to save the setting.
Figure 2
SET
▲
▲
Figure 3
3”
SET
+ -
IN
4
2
6
TB
-
3”
14 20
14 20