16
1
IN
4
6
6-3 Synchronize the channel
(1) Press “Set” button fon the receiver for 3 Seconds, the group (G) in the “Group & Channel”
area will flash. (Figure 4)
(2) Press “ Up ” or “ Down ” button to select a desired group
(3) Press “Set” again and the Channel (CH) in the “Group & Channel” area will flash.
(4) Press “ Up” or “ Down” button to select a desired channel.
(5) After setting, press “Set” again to save the settings.
(6) Press “REMOSET” to synchronize the channel of a transmitter. (Figure 5)
(7) If the channel of the transmitter fails to change, the “REMOSET” key will keep flashing.
Notice 1: The transmitter has to be set to “synchronization on (SYnOn)” in order to allow the
receiver to synchronize.(Handheld and body Pack Setting List p.17 )
Notice 2 : When setting the channel, system will automatically avoid the channel used by the
other channel.
6-4 Check system status
(1) Antenna Status: the receiver will automatically select an antenna with stronger signal recep-
tion and highlight that antenna (Figure 6)
(2) Battery indicator: the receiver’s battery indicator will show the same gauge as the transmitters.
If the transmitter is under low battery status, the receiver LCD backlight will be on amber.
18
6
16
2
3
4
AF
RF
Figure 5
AF
RF
Figure 4
Figure 6
AF
RF
Figure 7
AF
RF
3”
