Features:
This series adds ON/OFF switch to provide flexibility to installation.
LED indicator gives confidence to a speaker.
■
Definitive polar pattern allows for demanding sound pickup applications.
■
The small diameter gooseneck design permits flexible position.
■
High sensitivity allows for quality sound pick-up under difficult conditions.
■
Equipped with XLR connector.
■
Foam Windscreen provided for shielding against wind noise and "popping".
GM-SW Series Gooseneck Microphones
Specification:
Installation:
GM-5206SW / GM-5212SW / GM-5218SW / GM-5225SW
1. Plug connector directly into a 3P XLR jack on a microphone base or conference table. (Figure 1)
2. Equipped with built-in power module, that an external 12V ~ 48V phantom power is required. (Figure 2)
3. Press ON/OFF switch to turn ON the power and press again to turn OFF the power. (Figure 3)
4. Adjust gooseneck for aiming the microphone toward the proper sound source. (Figure 4)
5. Slip on windscreen over the microphone head to eliminate breath and popping noise. (Figure 5)
(Figure 4)
(Figure 5)
(Figure 2)
(Figure 3)
(Figure 1)
mixer
Type
Frequency Response
Sensitivity
Polar Pattern
Impedance
Max. SPL for 1% THD
Signal To Noise Ratio
Power Supply
Switch
Output Connector
Length
Electret Condenser
80
∼
18,000Hz
-56±3dB*(1.58mV)*0dB=1V/μbar
Supercardioid
Rated impedance is 100Ω
125 dB
74 dB
12~48VDC phantom power
Push ON/OFF
3P XLR (M)
GM-5206SW: 6”(152mm)
GM-5212SW: 12”(305mm)
GM-5218SW: 18”(457mm)
GM-5225SW: 25”(636.7mm)
+10
0
-10
20 100 200 500 1k 2k 5k 10k 20kHz
}
}
125Hz
250Hz
500Hz
1000Hz
2000Hz
4000Hz
8000Hz
16000Hz