©JRI Maxant
15
XIII.
INTRODUCTION
Congratulations, you own a SPY RF U (Universal) ! This device is equipped with 1 or 2 inputs (analog or
logical…). It enables you to record 1 or 2 physical parameter (depending on the model) and to transfer wireless
the recorded data by radio frequency to Sirius software installed on a PC through to a Spy RF Modem managed
by Sirius.
The SPY RF U complies with EN 12830, only with temperature probes.
a)
Equipment
1 SPY RF U1 (1 input) or U2 (2 inputs)
1 wall-mounting bracket
1 adhesive plaster
1 PT100 sensor (depending model)
1 Gauging certificate (depending model)
1 connector protection
1 user manual
b)
Symbols
• Do not use the unit in conditions other than those described in the technical
• Risk of fire or explosion in the event of misuse:
- Charging the battery
- Short-circuit the battery
• If the unit is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be compromised.
RECYCLING : do not throw in a rubbish dump or in a domestic waste container. Comply to the regulation to throw away
the device.
Power : This unit is power by a lithium AA battery in 3.6VDC-10µA
.
CE MARKING :this equipment is certified to comply with the European regulation for the electric security, inflammability,
disturbing radiation emission and immunity to surrounding electric disturbances.
FCC ID : W45 03330
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation
In accordance with FCC requirements, changes or modifications not expressly approved by JRI Maxant could
void the user's authority to operate this product.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
