JRC NQA-1951A, Instruction Manual

Page: 30 / 37

Appendix A: AT Commands Appendix A: AT Commands
A-1 AT commands input A-1 AT commands input
This section describes how to setup a terminal communication software to setup NQA-1951A This section describes how to setup a terminal communication software to setup NQA-1951A
using AT commands. using AT commands.
Step 1 Step 1
To run “HyperTerminal”, Click To run “HyperTerminal”, Click “START”, “START”,
point to point to “Accessories” “Accessories” , , “HyperTerminal” “HyperTerminal”
and then click and then click “HyperTerminal” “HyperTerminal” . .
Step 2 Step 2
Click Click “Cancel” “Cancel” . .
Step 3 Step 3
Click Click “File” “File” , and then click , and then click “Properties” “Properties” ..
Step 4 Step 4
Click “ Click “ Connect To Connect To ”, and then select ”, and then select
the communication port to communicate the communication port to communicate
with NQA-1951A in the list showed with NQA-1951A in the list showed
by clicking by clicking “ ” “ ” ..
ex. ex.
When communication port No.1 When communication port No.1
connects to NQA-1951A with communication cable, connects to NQA-1951A with communication cable,
Select Select “COM1” “COM1” ..