5-40
5.5.4 Connectors on the WT Adapter
Figure 5-24 Connecting Section of the WT Adapter
c
ANT port: (Connector type: RJ-45)
This is the port to connect the WT to the WT adapter. Use a straight cable between the WT
and WT adapter.
Shape: RJ45 connector
Specification: Ethernet signal (MDI-X specification)
The four remaining idle conductors are used for power and LED control.
d
PC port: (Connector type: RJ-45)
This is the port to connect the communication terminal.
Shape: RJ45 connector
Specification: Ether signal (MDI-X specification)
Connect the local management tool terminal using a straight cable.
Use a cross cable to connect the hub.
Use a straight cable to connect a PC or router.
e
DC jack: (+24VDC power supply)
Connect the AC adapter that comes with the WT.
PROHIBITION: Never connect a communication terminal to the ANT port of the WT adapter. Doing
so may damage your personal computer.
CAUTION: The cable connecting between the WT and WT adapter carries 24 VDC for the WT in
addition to Ethernet signals. Before unplugging the cable connecting between the WT and WT adapter,
make sure to unplug the DC jack of the WT adapter to turn the power off. Otherwise, the unit may be
damaged.
CAUTION: The cable connecting the WT and WT adapter is a straight cable. Wrong connection may
damage the unit.
CAUTION: PC port: (Connector type: RJ-45
②
)The Equipment for connection to WT adapter
PC-interface(RJ-45) shall be appropriate to connect to TNV-1 circuits.
②
8 7 6 5 4 3 2 1
1
2
3
4
5
6
7
8
RXD+
RXD-
TXD+
NU
NU
TXD-
NU
NU
1
2
3
4
5
6
7
8
RXD+
RXD-
TXD+
LED1
LED2
TXD-
+24V ̲OUT
GND
①
8 7 6 5 4 3 2 1
Top view
Bottom view
e
c
d
