42 | Operation
2.5.2.3 Ethernet Configuration (ETH CONFIG)
The AlphaLine instrument has one network interface to connect to a ship's network.
This can be useful when the instrument is connected to a remote interface or a PLC which uses Modbus/TCP. The
Ethernet interface can also be used for IEC 611612-450 signals.
Note This option has been included for future use.
Figure 38: Ethernet Menu
Figure 39: Numeric Pad
1. In the MENU, touch the ADV SET button.
The PASSWORD screen appears.
2. Key in the password and confirm with the
√
button.
The ADVANCED SETTINGS MENU appears.
3. Touch the ETH CONFIG button.
The ETHERNET screen appears, see Figure 38: Ethernet Menu on page 42.
4. Touch the bar below IP ADDRESS, SUBNET MASK, or GATEWAY to change these.
5. Touch the numbers to insert new numbers and touch the X button to delete numbers.
6. Touch the
√
button when numbers are correct.
7. Touch the
√
button again to confirm the IP ADDRESS, SUBNET MASK and GATEWAY settings.
Summary of Contents for AlphaWind AlphaLine MFL
