Figure 8: Place Frame on Cutout
Figure 9: Screw Fix Frame
Figure 10: Place Display Unit
Figure 11: In Place
1. Mount the display unit in a bridge console, or similar structure.
Note Plug in the Ethernet cable, if the network features of the display unit will be used.
2. Screw fix the frame with four screws to the cutout where the Display Unit is to be placed.
Note Screws are provided.
3. Place the Display Unit into the cutout and firmly press down on the four corners.
Note Snap-on clips are located on the back of the Display Unit, which fit exactly into the four holes provided
in the mounting plate. See Figure 35: SSRD Display on page 40.
To remove the display firmly grip the panel with the tops of the fingers and pull backwards and up at the same time. Do
not use screwdrivers as these will damage the display cover and paint work of the console.
The display unit has a mute closing contact, this can also be attached to the fog horn system on the ship. This contact
suppresses detection when the contact is closed and begins again when it is open.
Advanced configuration options can be performed using the web interface.
13 | Installation
Summary of Contents for Alphatron SSRS
