52 | Operation
2.3.8 Simulation
This chapter explains functionality in simulation mode. Before selecting simulation mode the system should not be in
control. During simulation mode Set Points will not be output to the thrusters. This mode is for testing, demonstration and
educational purposes.
Figure 41: Simulation Screen
The SIMULATION tab will blink in red during simulation (Figure 41: Simulation Screen on page 52). After changing
into simulation mode two sensors of each type will be available.
Typical simulation settings of these sensors can be altered on the simulation screen. Other screens can be used to
operate the system, same as in non-simulation (real) mode.
2.3.8.1 Setting Environment in Simulation mode
The environment can be set to change the system behavior in a particular wind and current conditions.
Figure 42: Environment in Simulation Mode
1. Refer Environmental area on Simulation Screen.
2. Double click on the (yellow) number to change following settings:
Summary of Contents for Alphatron Marine AlphaDynaPos
Page 1: ...AlphaDynaPos Ship Automation and Navigation system Operation Manual www jrc am ...
Page 5: ...5 Contents 4 2 Appendix B Checklist for Taking DP system into Operation 85 ...
Page 13: ...13 Introduction III 3 System Overview DP2 Figure 2 system Overview DP2 ...
Page 14: ...14 Introduction III 4 Sensor Overview Figure 3 Sensor Overview ...
