50 | Operation
Weighing section:
•
Parameter for filter time (moving average filter, default set at 4sec.).
•
Parameters for adjusting factors for the weighing rating / deviation / error (0~10).
•
Display of difference absolute (weighed).
•
Error North / SOG North.
•
Error East / SOG East.
•
Resolved absolute position via weighed absolute position reference.
•
Resolved difference relative used by the DP controller.
•
Error X / SOG X.
•
Error Y / SOG Y.
Sensor location section:
•
Parameter table to set the X / Y / Z offset of the reference device to the center of the vessel.
2.3.7 Follow
To make the DP system follow one particular sensor the Follow mode must be engaged. First set system into Auto-
Position mode to enable Follow mode.
1. Select POSITION screen (Figure 39: Position Screen (F.U.) on page 50).
2. Select sensor as F.U. (Follow Up).
3. Select Follow on the FOLLOW screen (Figure 40: Follow Up (F.U.) on page 51).
Figure 39: Position Screen (F.U.)
Summary of Contents for Alphatron Marine AlphaDynaPos
Page 1: ...AlphaDynaPos Ship Automation and Navigation system Operation Manual www jrc am ...
Page 5: ...5 Contents 4 2 Appendix B Checklist for Taking DP system into Operation 85 ...
Page 13: ...13 Introduction III 3 System Overview DP2 Figure 2 system Overview DP2 ...
Page 14: ...14 Introduction III 4 Sensor Overview Figure 3 Sensor Overview ...