JRC Alphatron LT-3100 Iridium, Installation & Operation Manual

Page: 34 / 52

34 | User Interface (UI)
7.2 System information
The Alphatron LT-3100 Iridium installation and mounting is described in the previous sections. After
the Alphatron LT-3100 Iridium has been installed and properly connected, the system will
automatically start-up and register on the Iridium® Network and be ready for use. The Alphatron LT-
3100 Iridium will inform the user, if the system is not properly installed, or the system cannot register
onto the Iridium® Network. Figure 21 is illustrating a Alphatron LT-3100 Iridium, which is registered
on the Iridium® Network and ready to use. The Alphatron LT-3100 Iridium will provide user
information in the status bar and status text (e.g.
‘R egistered ’ showed below the Iridium® connected
logo).
Figure 21: LT-3110 Control Unit - UI display (status view)
The signal strength icon will be showed with a signal strength between 0 and 5 (where 5 is the
maximum signal strength), when the Alphatron LT-3100 Iridium is registered on the network and
ready to use. If no signal is available, the signal bar symbol will be showed with no highlighted bars
and a small cross. The status text will show ‘Registered’ if the system is ready to use. Table 5 gives an
overview of the possible combinations, of the signal strength icon, and the status text that the
Alphatron LT-3100 Iridium can represent.
Signal Bar System Text System Status
0 to 5 Registered Ready to use
0 to 5 Registering… Not ready
No bars (with cross) Searching for Iridium… Not ready
Table 5: LT-3110 Control Unit – Registration status