30
The Direct Mode function of the XR3i is accessible through
the use of the electronic throttle or steering trim levers, as
well as the two electronic grip levers (A&B) located on the
upper portion of the grip handle. This function allows for
quick trim adjustment of these controls.
To access the Direct Trim Mode function, turn on the
transmitter power switch. Next, move the desired trim lever
to be adjusted. The appropriate screen for the selected trim
lever will be displayed. To adjust, simply move the trim lever
in the desired direction until the correct amount of trim is
achieved. Once the desired trim is achieved, the screen will
return to the Normal display screen after approximately two
seconds from the last trim input. If the
Increase
or
Decrease
keys are pressed any time during the two seconds, the
system will return to the previous screen in use.
stc
0
thc
0
aux
0
brk
50
E P A
stg
70
∞
R A T E
Steering Trim
(page 31)
Only present when Aux. function “O” is selected
Only present when Auxiliary function “LN” is selected
Throttle Trim
(page 32)
Steering Dual-Rate
(Grip Lever B)
(page 33)
Brake Travel Adjustment
(Grip Lever A),
(page 34)
(Only visible when the
Auxiliary Channel 3
function “O” has been
selected.) Refer to
Auxiliary Channel 3
function, page 16, for
clarification.
Auxiliary Channel 3
Trim Adjustment
(LN mode only)
Refer to Auxiliary
Channel 3 function,
page 35, for
clarification.
*Note:
When Auxiliary Channel 3 function 2P is
selected, the two screens above are not present.
*
*
T R I M
T R I M
R/B
Accessing the Direct Trim Mode
4680 JR XR3i manual 7/17/02 12:14 PM Page 30
