Part Number
Description
FHT1000
HoverCross RTF, Red
FHT1001
HoverCross RTF, Blue
FHT1002
Propeller Set (4) Red; HoverCross
FHT1003
Propeller Set (4) Blue; HoverCross
FHT1004
Replacement Motor; HoverCross
FHT1005
Decal Sheet, Red; HoverCross
FHT1006
Decal Sheet, Blue; HoverCross
FHT1007
USB Charge Cable; HoverCross
FHT1008
2.4GHz Transmitter; HoverCross
Open the battery compartment and insert three AAA batteries
Make sure that you match the polarities (+ and -) as marked inside
Replace the cover and screw in place
Installing Batteries
•
Place the HoverCross on a flat surface as in hover mode
•
Plug the mini USB on the charge cord as shown and the
USB charger into a 5V USB power source
•
Green LED’s show while charging and turn off when
charge is complete
•
Charging should take between 35 and 40 minutes
•
When the charge is complete, unplug both connectors
•
Use only the included USB charge cord
Charging Instructions
Charge Port
On/Off
•
Press the On/Off button on the transmitter. Press and hold the On/Off button on the aircraft
until the LED lights begin blinking. Move the left stick up for one beep and all the way down
until you hear another beep. The transmitter is now paired with the HoverCross and the red
LED’s will stop flashing.
•
In hover mode, press the Auto-Take Off/Land button or move the left stick up and the Hover
Cross will begin to move forward. To take off in drone mode, press the Auto-Take Off/Land
button and the unit will climb to an altitude of 1.5 to 2 meters and maintain a steady hover.
•
See the transmitter diagram for movements and control during operation.
•
If the HoverCross tends to “drift” in any direction during flight, use the trim buttons as shown in
the transmitter diagram.
Operating Instructions
•
•
•
Forward
Backward
Move Left Move Right
Ascend
Descend
Rotate Right
Rotate Left
360° Flips (R)
Mode Flips (L)
ON/OFF
Trim Forward/Backward
Trim Left/Right
3 Rates Slider
