11
M
IC
IN
×óÉùµÀ
ÓÒÉùµÀ
¶ú»ú¿×
X
BL-8008 Manual
BL-8008 Manual
(3) After make sure the transmitter and audio cables are connected well,
switch on the transmitter, the power indicator will be on, this means
transmitter is working. Face the transmitter's IR window to the receiving
area. Adjust the audio source in working status and turn up its volume
properly (when transmitter connects to STB, DVD, PC, etc)
(4)Make sure the receiver's IR window toward transmitter, switch on
the receiver, its power indicator will be on, then you will hear the
sound from transmitter, adjust the volume properly, if the volume is
not loud enough, please turn the volume of audio source louder until
the volume meets your requirement.
Audio out
Connect to audio out of DVD
Connect to audio out of PC
BL-8008
Note: Because this product adopts infrared wireless technology, when
you ensure that you have connected the parts well, please note as below:
a.Transmitter should be put on the higher place, like the top of TV.
12
MI
C I
N
LIN
E IN
BAL
VOL
TONE
ON
OFF
TONE
TONE
TONE
BAL
BAL
VOL
BAL
MI
C I
N
LIN
E IN
BAL
VOL
TONE
ON
OFF
L
R
L
R
(5)Frequency response: Rotate the
TONE
in best position, make sure
you can hear the TV sound clearly.
¡°
¡±
(6)Balance adjustment: If the hearing ability of two ears is not the same,
you can use the adjust driver to adjust the BAL, make sure the
volume meets your requirement.
b.The infrared window of transmitter should be faced to the receiving
area.
c.The infrared window of receiver (ordinarily refer to the side with
logo) should be faced to the transmitter.
Noise will occur when run into the below situations:
a.There is obstacle between the transmitter and receiver.
b.The transmitter is put at a very low place.
c.The receiver is too far away from the transmitter, or deviation angle
is too large.