Joyner JNSZ650UV4S, Owner'S Manual

Page: 23 / 76

23
beam and the taillights.
Do not use the headlights with the engine turned off for an extended period of time.
The battery may discharge to the point that the starter motor will not operate properly.
If this should happen, remove the battery and recharge it.
Turning light switch
“
/
”
Set the switch to “ ” when turn left
Set the switch to “ ” when turn right
Four-wheel drive switch “2WD/4WD”

Two-wheel drive ("2WD"): Power is supplied to the rear wheels only.

Four-wheel drive ("4WD"): Power is supplied to the rear and front wheels.

To change from 2WD to 4WD, the vehicle should stop fully. It will make some parts
of the electric locker can’t work that changing from 2WD to 4WD when the vehicle is
moving.

To change from 2WD to 4WD successfully, you should try more times, and then
start the engine slowly back and forth.

You should try again if there is some nonnormal voice when the speed is about
20Km after changing from 2WD to 4WD.
Winch
switch “in/out”
Set the switch to “in” to reel rope in.
Set the switch to “out” to reel rope out
.
Reverse indicator light “R”
This indicator light comes on when the drive select lever is “R” reverse position.
Electricizing of the battery indicator light
This indicator light comes on when the generator of the engine can’t electricize the
battery. You should check the generator and battery or get help from your JOYNER
dealer .
Spot light switch
Set the switch to turn on the spot lights.
Pedal
Clutch pedal