4
Adjusting lever released= shortest trimming length
Adjusting lever pressed= maximum trimming length
WARNING: when you fit or remove the clip-on comb, the appliance should always be off.
In order to set the cutting length, it is necessary to proceed in the following way:
Push completely the slide knob
Then push the adjusting lever in order to get the chosen cutting length : 2/3/6/9/12/17mm
ISTRUCTIONS FOR A CORRECT USE OF THE HAIR CLIPPER
It is important to cut always the hair “against the grain”, that is to say against the direction in which
the hair grows.
Clipping without comb attachment
Always comb the hair in the direction of growth before clipping.
Set the cutting length, as described in the section “CUTTING LENGHT ADJUSTMENT”
Hold the clipper so that the flat side of the comb attachment is parallel to your head and move the
appliance slowly.
Clipping with comb attachment
The comb attachment can be used in order to obtain hair lengths up to 17 mm.
Before switching the appliance on, always select the cutting length.
Important: always move against the direction of the hair growth.
Place the comb on the neck and move it slowly, cutting small locks.
It is possible to change the length setting, in order to obtain different lengths on different parts of the
head, always refer to section “CUTTING LENGTH ADJUSTMENT”
In order to obtain cutting shades, it is possible to use the styling comb too
This particular procedure should be followed in case you want to obtain hair
length over 17 mm.
First of all, remove the clip-on comb.
Lift a small hair lock with the styling comb in order to get the preferred length.
Trim the hair over the styling comb.
Go on with such procedure, clipping always against the hair growth direction.
Comb frequently to remove the cut hair and check for unevenly cut sections.
At the side part, continue the transition to the left temple first and then the right
one,with the trimmer slightly inclined.
For cutting the hair around the ears, put one edge of the cutter on the skin;make
sure the teeth are kept at a safe distance fromthe ears.Next start again at the back
and cut the transition as already described in order to reach the right temple.
In order to cut the fine transition at the start of the neck,press slightly the adjusting
lever and guide the trimmer approximately 1-2 cm from the bottom upwards.
Remove the last remaining hair from the neck, moving the adjusting lever of the
trimmer completely out.
In order to adjust the power (max 1 minute) , turn the screw in a clockwise
direction until the arm strikes the coil, making a noise.
TECHNICAL FEATURES
Power supply: 230-240V~ 50 Hz
Power: 10W
Stainless steel blades
5
