3. OPERATION
Connect your USB
-
PD trigger module to a USB
-
PD compatible power
supply using the interface explained above. The free solder pads on the
back of the board are used to connect the load. These modules provide
you with different voltage modes, which are indicated by the LED.
Colour
Voltage mode
■
5 V
■
9 V
■
12 V
■
15 V
■
20 V
■
Maximum possible voltage of
the power supply
■
Runs through all modes
(one per second)
To set the modes as default, first plug the board into your power supply
while holding down the button on the board. Now the LED will start
flashing colourfully. Now you can select the desired mode using the
button. Now press and hold the button to confirm your selection. Finally,
disconnect the power supply from the module and then reconnect it so
that the module now starts directly in this mode.
