10
3)Sleep mode
When the
i
Solder-40 controller senses no usage for 5 minutes, the
i
Solder-40 starts the
sleep mode for saving power.
The indicator of this mode is a flashing red led
(short on; short off)
.
To get out from sleep mode and turn to operating mode, move the hand
piece from the holder and wait until the iControl automatically senses and
update the status from Sleep to Operating mode.
4)Power saving mode*
After 10 minutes in the sleep mode, the
i
Solder-40
will turn to the power
saving mode, where no power is delivered to the tip at all and the tip
temperature drops down to room temperature.
The power saving mode is a safety mode where the device can get out of it
by moving the hand piece to left or right direction.
Also to shift from operating mode switch Off/On the
i
Solder-40
The indication of this state is a flashing red led
(short on; short off)
.
*
The difference between the sleep mode led color indicator and the auto shut-down mode led color
indicator is the speed of flashing.
For sleep mode the led red flash speed is Off/on in seconds is 1/1.
For standby mode the led flash speed is Off/on in seconds is 5/1.