12
Installing the log store and base
Fig. 7
A
B
C
1. Centrally position the log store
(A)
approx. 120 mm in front
of the fireproof board
(B)
. Apply acrylic adhesive along the
front edge
(C)
.
Fig. 8
A
2. Push
the
base
(A)
against the firewall.
Fig. 9
3. Make sure that the log store is glued to the base
Preparing the air intake of the insert
Fig. 10
A
B
C
D
1. Unscrew the two screws
(B)
and discard the air intake
connector
(A)
.
2. Then unscrew the two screws
(D)
beneath the burn chamber
and remove the cover
(C)
.
3. Secure the removed cover over the air intake hole at the rear.
Secure it in place using the same screws.
4. Continue the installation of the adpater. Screw the adaper
on to the underside of the burn chamber where the cover
(C)
was positioned.
Continue by following the installation
instructions from Fig. 11 in the main
manual for the Jøtul FS
73/74
(item no.
10046753/10046791).
ENGLISH
