jotron.com
Page 21 of 56
3.5.5
Testing of the AIS locating signal
During standard self-test mode, the EPIRB will transmit two text messages
with the 15HEX ID in one message and the text EPIRB TEST in the other
message. The figure below shows this text message as shown on the Jotron
TR-8000 MkII AIS.
When doing GNSS self-test the position messages are also output together
with the text messages.
Normally AIS stations will suppress AIS SART test messages but can be
configured to display the test information. If an AIS installation is going to
be used to verify AIS SART test messages, please consult the equipment
manual of the AIS system for more information about this.
3.6
Deactivation of the EPIRB
If the EPIRB has been accidentally activated or to deactivate it after use,
remove it from the water and move the switch back to its middle position.
Note that it can take up to 15 seconds before the strobe light stops
flashing.
