6
Eng
lish
4.1
Cleaning
The landing gear is to be cleaned with the vehicle. No special cleaning is
required.
Do not direct the jet of a high pressure cleaner straight at the gearbox ope-
ning.
4.2
Servicing interval
4.3 Lubricants
For greasing the gear
Lubricating grease, conventional
For greasing the spindle and spindle nut
BP JS 14-2 / Renolit LZR 2H special grease
Wind the winch out as far as it will go on the shaft.
Open the lubrication hole by removing the sealing stopper (1).
Fill the grease trough in the spindle nut with approx. 200 g special
grease.
Turn the spindle in and out as far as it will go and then back in again.
Seal the lubrication hole again with the sealing stopper (1).
Only use the genuine JOST part JS E0084000 when using a grease
nipple.
Servicing work
Servicing interval
Note
Grease spindle and
spindle nut
After 3 years
1st service intervall
Grease spindle and
spindle nut
Annually
After the 1st service
intervall
Check the spindle and
spindle nut for wear
Annually
After the 1st service
intervall
Inspect the landing
gear for cracks and
deformations
Each time you use the lan-
ding gear
Repair the landing gear
immediately if it is
damaged
!
Using other parts can result in damage to the landing gear.
JSK-ST/22
1
4
Servicing
JSK-Modul-en-26.04.05.fm Seite 6 Dienstag, 26. April 2005 2:00 14
