4
© Josef Kihlberg AB 2007
EN
Adjust to the lowest air pressure that will bend the staples
correctly. Start at about 5.0 bar and increase the pressure
by 0.5 bar increments until the pressure is correct.
Never exceed 8 bar.
Low air pressure helps to keep down maintenance costs.
The tool is adjustable for 15 or 18 mm staples. The tool
setting for a different staple leg length is altered as follows.
Start by adjusting the depth of stapling for deep clinching
(=) as shown in the upper picture.
Then in order to adjust to required leg length.
1. Slacken the locking screw (A) underneath with a 2.5 mm
Allen key.
2. Set to the required staple leg length.
3. Tighten the locking screw.
The depth of the stapling claws is easily adjusted using
the setting knob. Depress the knob and turn it to the
required position.
- Shallow stapling
= Deep stapling
It is possible to adjust how tightly the staple is closed.
Turn the adjusting nut clockwise (A) to close the staple
tightly and anticlockwise (B) to close it less tightly.
Tool use
