2
3. How to set up a Bluetooth connection with
Android devices
S
Step 1 Configure output interface of the scanner to
be H
HID by scanning the sequence of barcodes as
the below figure shows
.
Step 2 Switch your scanner to Bluetooth Mode
.
Step 3 Pair your scanner with Android devices
.
Step 4 Turn on Bluetooth setting in your Android
device. From the list of available Bluetooth devices,
appropriately select the device which your intend to
pair Android phone with.
Step 5 According to the pop-up message which
contains PinCode info, please properly scan the
sequence of decimal barcodes from
Decimal/Hexadecimal Table in Section 2. Then, scan
SET label in the same table to initiate the pin code
verification.
Step 6 After Bluetooth connection is successfully
established, launch a text editing application to
receive barcode data.
4. How to set up a Bluetooth connection with
termial programs via SPP Master interface
Step 1 After the Bluetooth dongle is secured into Host
PC, please go to C
Control Panel>B
Bluetooth Settings.
Step 2 In B
Bluetooth Settings, click on C
COM Ports tab
and then hit A
Add button to add an incoming port.
Step 3 In A
Add COM Port dialogue box, select IIncoming
option and then hit O
OK button to initiate the process.
Step 4 Back to B
Bluetooth Setting, if the incoming port
is successfully generated, the list box in C
COM ports
tab will show associated information regarding the
incoming port.
Step 5 Launch the terminal simulation application
to configure COM Port with the incoming port you
generate in step 4 and ensure the application is
connected using specified COM port.
Step 6 Configure output interface of the scanner to
be S
SPP Master by scanning the sequence of
barcodes as the below figure shows.
Step 7 Follow the below steps to configure pin code
information.
*/$%ENTR*
e shows
.
ENTER
*ZEND*
END
*5OZ3*
HID
*/$%ENTR*
ENTER
*ZPAR*
BT Pairing
*95C+*
BtPinCode
*/$%ENTR*
ENTER
Scan the sequence of
barcodes
corresponding to the
desired pin code from
decimal/hexadecimal
table in Section 2.
*%OK*
SET
*ZEND*
END
*/$%ENTR*
ENTER
*ZEND*
END
*5OZ2*
SPP Master
*/$%ENTR*
ENTER
*ZTOB*
To BT Mode
