Caboose Ultralight Instruction Manual
Page 11
Figure 24
Figure 25
Figure 26
Using the Stroller as an
Infant Car Seat Carrier
• To use the stroller to carry an infant car seat
carrier, you must replace the Front Tray with
the Car Seat Carrier Support.
• Remove the Front Tray (See page 6) and store
the tray in a convenient place for later use.
• Line up the female fittings on the Car Seat
Carrier Support to the male fittings on the front
of the stroller and push inward until the fittings
snap into place. See Figure 24. Pull outward
on both sides of the support to be sure both
are snapped securely in place.
• Push the canopy to its most rearward position.
• ADJUST THE SEATBACK TO ITS 2
nd
POSITION. THIS IS THE MIDDLE OF THE
THREE RECLINE POSITION.
• Remove the infant carrier from the car seat
base.
• Place the infant carrier onto the top of the
stroller in a REAR FACING POSITION, locating
the head end of the carrier so that it rests on
the Car Seat Carrier Support and the feet end
of the carrier so that it rests on the seatback,
but NOT on the top edge of the seatback. See
Figure 25.
• Ensure that the head end of the infant carrier is
pushed down firmly inside the frame of the Car
Seat Carrier Support and that it is centered
side to side.
• Remove the carrier restraining straps from the
pouches on both sides of the stroller. Buckle
them in place over the LOWEST part of the
carrier sides. Adjust the straps so they are
tight around the carrier but AWAY from the
child’s neck. Pull up on the carrier to be sure it
is held on securely. See Figure 26.
• Always check frequently to be sure that the
restraining straps are tight across the infant
carrier but away from the child’s neck.
• When you remove the infant carrier from
the stroller, unlocked the restraining strap by
pressing the button and both side releases. See
Figure 27.
• Always replace the two restraining straps back
into their side pouches.
Figure 27
