English –
19
ASSEMBLY
• Fit the appropriate
guard (A) for use with
the trimmer head. Hook
the guard onto the shaft
fitting and secure it with
the bolt (L).
• Fit the disc drive (B) on
the output axle.
• Turn the blade axle until
one of the disc drive’s
holes aligns with the
corresponding hole in
the gear housing.
• Insert the locking pin
(C) into the hole to lock
the axle.
• Screw on the trimmer
head (H) in the
direction of rotation.
• Dismantling takes place
in the reverse order.
Assembling other guards and
cutting equipment
H
Adjusting the harness and clearing
saw
Quick release
On the front is an easily
accessible, quick release
catch. Use this if the engine
should catch fire or in any
other emergency situation
when you quickly need to
take off the harness and
machine.
Even load on the
shoulders
A well-adjusted harness and
clearing saw significantly
facilitates working. Adjust
the harness for the best
working position. Tension
the side straps so that the
weight is evenly distributed
across the shoulders.
Correct height
Adjust the support strap so
that the cutting attachment
is parallel to the ground.
Correct balance
The cutting attachment
should rest lightly on the
ground. If you use a saw
blade it should balance
about 10 cm above the
ground to prevent contact
with stones and the like.
Adjust the position of the
support strap attachment
ring to balance the clearing
saw correctly.
!
WARNING!
When working with the clearing saw it
should always be hooked in the harness.
If this is not done, you cannot control the
clearing saw safely and this can result in
injury to yourself or someone else. Never
use a harness with a defective quick
release catch.
