English
– 17
Maintenance
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
1)
First change after 8 hours.
2)
Clean and replace the filter more often in dusty conditions.
3)
If the machine is used daily it should
be lubricated twice a week.
4)
Conducted by authorised service workshop.
5
First change after 8 hours. (Only 4x4-machines)
X = Described in this operator's manual
O = Not described in this operator's manual
Maintenance
Daily maintenance
before starting
At least once
a year
Maintenance
interval in hours
25
50
100 200
Cleaning
X
Check the engine’s oil level
X
Check the engine’s cooling air intake
X
Check the fuel pump air filter
X
Check the steering wires
X
Check the brakes
X
Check the battery
X
Check the safety system
X
Check nuts and screws
O
Check for fuel and oil leakage
O
Clean around the silencer
O
Check the muffler
X
Change engine oil
1)
X
X
Replace the air filter’s prefilter2)
X
Check the cutting deck
X
Check the air pressure in the tyres, 60 kPa/8.5 PSI.
X
Lubricate the belt adjuster
3)
X
Lubricate joints and shafts
3)
X
Check the V-belts
O
Check the transmission’s cooling fins
O
Check transmission oil level
X
Check/adjust parking brake
X
Checking and adjusting of throttle wire
X
Clean the engine’s and transmission’s cooling fins
2,4)
O
Replace the air filter’s pre-filter and paper filter
2)
X
Replace the fuel filter
X
Replace the spark plug.
X
Check the need to change the oil
4,5)
in the gearbox/
hydraulic system
O
O
Check the fuel hose. Replace if necessary .
4)
O
!
WARNING! No service procedures must be
conducted on the engine or cutting unit
unless:
The engine is switched off.
The ignition key is removed.
The ignition cable has been removed from
the spark plug.
The parking brake is applied.
The cutting unit is disengaged.
