Jonsered FR 2213 MA, Workshop Manual

Page: 21 / 56

12. Remove the screw for the rear fastener of the center
spring.
13. Remove the inner circlip (A) from the lower bearing.
A B
14. Remove the rear axle.
15. Remove the outer circlip (B) and lift out the lower
bearing.
16. Lift the top bearing from above. If it is necessary, tap
the bearing from below.
17. Attach the new bearings.
18. Assemble the articulated steering in opposite
sequence.
19. Do a check of the tension of the steering cable.
See To examine and adjust the steering cables on
page 44.
20. Do a check that the control and cables are correctly
adjusted. See
To replace the hydrostat cable on
page 36.
21. Do a function test of the product.
22. Bleed the hydraulic system and fill the transmission
oil tank with oil. See
To bleed the drive system on
page 30.
8.2 Propulsion system
8.2.1 To remove and install the engine
1. Remove the engine cover. See To remove the
covers on page 16
2. Disconnect and remove the battery.
3. Disconnect the cable between the starter relay and
the starter.
4. Make marks on the electrical connectors and
remove the electrical connectors from the engine.
5. Remove the clips that hold the throttle cable and, if
attached, the choke cable. Disconnect the cables
from the carburetor casing.
659 - 001 - 11.04.2018 Repair instructions - 21