English
– 11
ASSEMBLY
Fitting the main body
Connect the engine (A) to the tube (B) with four screws (C).
Fitting the handlebar
•
Fit the handlebar in the handlebar clamp on the shaft
using six screws.
•
Attach the cabling to the shaft with two cabling holders.
•
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness.
Connecting throttle cable and stop
switch wires
1
Remove the air filter cover.
2
Insert the throttle cable (A) through the carburettor bracket
(B), then screw the cable adjuster sleeve (C) into the
carburettor bracket fully.
3
Position the slotted fitting (D) on the carburettor so the
recessed hole (E) for the cable lug (F) is away from the
cable adjuster sleeve.
4
Rotate the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making sure the
cable lug drops into the recessed hole.
5
Operate the throttle trigger a few times to make sure that
it works correctly.
6
Adjust the cable adjuster sleeve so the stop on the
carburettor throttle cam just contacts the throttle stop and
the cable position keep 1-2 mm play between the cable
lug and the slotted fitting when the throttle trigger is fully
depressed.
7
When the throttle cable is adjusted correctly, tighten the
locking nut (G).
8
Plug the stop switch wires (H) into the matching
connectors from the engine. Note that wire polarity is not
important.
A
B
C
1-2mm
H
