- 6 -
EN
INDUSTRIAL GLASS AND DISHWASHER—USERS MANUAL
MACHINE DESCRIPTION
The main features of an INDUSTRIAL DISHWASHER, unlike those of a DOMESTIC DISHWASHER, are different in their
ability to wash big volumes of ware in a very short period of time. This requirement means that the design of an industrial ma-
chine is considerably different. Certain key paramaters of an industrial machine differ by:
The capacity of the basket;
Features of the type of dishwasher;
An industrial dishwasher can operate better when using demineralized water, with no impurities. In case this won’t be possi-
ble, a soft or softened water supply should be used (no calcium, magnesium in the water);
AISI304 heavy duty stainless steel boiler and machine construction;
Automatic washing and rinsing system;
Automatic water filling controlled by pressure switch;
Thermostatically controlled wash and rinse temperature;
Possibility to rinse glassware with cold water;
Possibility to stop the cycle by opening the door;
Automatically rinse aid pump;
Incoloy tank and boiler elements.
ELECTRICAL SAFETY REQUIREMENTS
Before any cleaning or maintenance, when required, press the switch 0/1 on the position 0 and switch off electrical pow-
er at the switch, turning it to OFF.
Do not replace the electrical power cable from the one provided. In case the power cable requires to be replaced, contact a
qualified electrician to replace it by a similar cable, Y Type.
Verify that the electrical values supplied to the machine meet with the demands as specified on the ratings plate of the
machine. If not, do not start the machine and call a technician.
Check that your electrical system complies with regulations and that the machine has been correctly earthed.
Do not open the door of the dishwasher while a cycle has been started. There is a danger of being sprayed by hot water.
Do not use the machine if the temperature around it is inferior than 5°C.
Do not use water to clean the outside of the machine.
Check that the incoming water pressure of the machine is between 2 and 4 bar (200 - 400 KPa).
Do not remove panels from the machine. Only qualified technical people should remove panels.
