Jolly Roger INTERNATIONAL SPEEDWAY CAR CAROUSEL, Handbook

Page: 16 / 34

JOLLY ROGER AMUSEMENT RIDES
Fuses
4.19 Fuses are located in the side of the multi PSU. Never replace fuses with a higher value than
recommended.
Body and other mouldings
4.20 Clean with damp cloth rinsed out in soapy water, do not hose down or flood the machine. Alternatively,
a proprietary household furniture cleaner may be used.
Removal of the three seats and the centre characters
NOTE
Refer to Spare Parts section for item numbers.
4.21 To remove the three seats:
4.21.1 Remove the nine set screws, nine repair washers and the nine spring washers from the
captive nuts installed in each seat.
To remove the centre characters:
4.21.2 Remove the three plastic nut caps, three bolts, three plain nuts, three nylock nuts and
the six plain washers.
4.21.3 Refit the seats and the centre characters in reverse order to the removal.
ALWAYS DISCONNECT THE MACHINE FROM THE POWER SUPPLY BEFORE
CARRYING OUT ANY SERVICE OR REPAIR.
Removal of base cover
4.22 To remove the base cover proceed as follows:
4.22.1 Remove the four hexagon retaining bolts, nuts and eight washers that secure the base
cover to the top frame.
4.22.2 Refit in reverse order to the removal.
Daily checks
4.23 A check of each coin-operated Kiddie Ride should, whenever reasonably practical, be carried out
each day before it is made available for the public. The following checks are recommended: -
4.23.1 Check that the mains plug is undamaged and securely attached to the mains cable.
4.23.2 Check that the mains cable is undamaged.
4.23.3 Check that there are no broken or damaged parts of the ride that may cause injury.
4.23.4 Check that all guards are in place thus preventing any access to the mechanism.
4.23.5 Apply pressure to the ride to ensure that it is firmly secured to the base stem and check
that all advisory literature is in place.
Page14