Jolly Roger INTERNATIONAL SPEEDWAY CAR CAROUSEL, Handbook

Page: 10 / 34

JOLLY ROGER AMUSEMENT RIDES
Coin acceptor (electronic) MARS
4.4 To remove/refit the coin acceptor proceed as follows:
4.4.1 Remove the coin acceptor by turning the lock situated on the faceplate and disconnect the
cable plug from the printed circuit board on the mechanism - the coin acceptor can now be removed
from the machine.
4.4.2 To remove litter from the coin acceptor, pull the hinged side plate sideways and remove any
litter or obstruction. Release hinged side plate.
4.4.3 Refit the coin acceptor in reverse order to removal, ensuring that the cable plug is reconnected
to the printed circuit board on the mechanism.
NEVER REMOVE OR REPLACE AN ELECTRONIC MECHANISM WITH THE POWER
SUPPLY SWITCHED ON.
Electronic coin mechanism MARS - switch positions
4.5 To inhibit coins:
With machine switched on:
4.5.1 Set slide switches as follows, 1 = ON, 2 = ON, 3 = OFF, 4 = ON.
4.5.2 Press reject button within 20 seconds of setting slide switches.
4.5.3 Insert all coins to be inhibited.
4.5.4 Press reject button within 20 seconds of inserting coins. Inhibited coins should now be
rejected.
4.6 To re-enable inhibited coins:
With machine switched on:
4.6.1 Set slide switches as follows, 1 = ON, 2 = ON, 3 = OFF, 4 = OFF.
4.6.2 Press reject button within 20 seconds of setting slide switches.
4.6.3 Insert all coins to be re-enabled.
4.6.4 Press reject button within 20 seconds of inserting coins. Previously inhibited coins should
now be accepted.
NOTE
Mechanism must be powered up before changing switch positions. Switch positions must be moved
prior to attempting either of the above.
Page 8