Jolly Roger INTERNATIONAL SPEEDWAY CAR CAROUSEL, Handbook

Page: 17 / 34

JOLLY ROGER AMUSEMENT RIDES
4.23.6 Ensure the area around the ride is free from obstruction and that persons passing by are not
in any danger.
4.23.7 The ride should be kept clean and free from any customised additions unless approved by
the manufacturer.
4.24 If as a result of the above visual checks any doubt arises, then the company, supplier or person
responsible for the ride should be notified immediately.
Motor
The motor is fitted with a manual re-set thermal overload cut-out device in accordance with UL requirements.
4.25 When the motor does not operate, check if the thermal overload cut-out device has operated and re-
set as follows:
When the thermal overload cut-out device has operated, investigate and correct the
fault before the ride is returned to use.
4.25.1 Disconnect the machine from the electrical power supply
4.25.2 Removing the access panel (see Fig 7). Turn the base to align access panel opening with
the motor.
4.24.3 Re-set the thermal overload cut-out button on the motor backplate.
4.25.4 Refit the access panel.
4.25.5 Connect the electrical power and test the ride.
Page 15