Surface Technology
Oberflächentechnik
8
Maintenance instructions
Please precisely follow the instructions below in order to achieve maximum service life
of the machine:
Daily maintenance
1.
Remove the protective hood (5.2 /1).
2.
Apply a couple of drops of oil, Diprofil FNA-K type (joke no. 0001287) or similar, to the
needle bearing of the coupling piece (5.2/5) after approx. every 8 hours of use.
3.
Only loosen the clamping screw (5.2/2) far enough to ensure that the FMP-2 bearing
bush is not lost.
4.
Pull the piston rod and tool holder (5.2/3) out of the machine housing.
5.
Carefully clean the piston rod and tool holder (5.2/3) with a soft cloth and apply a few
drops of oil, Diprofil FNA-K type (joke no. 0001287) or similar.
6.
Reinsert the piston rod and tool holder (5.2/3) into the guide bush. The piston rod must
be completely pushed into the coupling piece (5.2/5). For this purpose, bring the adjus-
table eccentric cam (5.2/4) into the forward position. Firmly tighten the clamping screw
(5.2/2) again.
7.
Reapply the protective hood (5.2/1).
Fig. 5.2 Exploded drawing of the hand-filing machine
