Joie mimzy snacker H1127, Instruction Manual

Page: 14 / 17

23
24
2. Open the highchair by rotating the backrest upwards (Fig. 4) . a“click”
means the backrest is locked completely.
!
Please confirm the recline wire and seat latch slot are fully engaged
before use. (Fig. 4.1)
!
If they are not correctly engaged, please fold the unit as Fig. 18 and
repeat the above operation.
3. Please attach basket to the support leg by 4 pairs of webbings (Fig. 4.2) .
Pull webbings upwords to remove basket.
4. Place the tray over tray bar (Fig. 5) while pulling the button on both sides
under the tray outward (Fig. 5.1) until a “click” is heard.
The assembled highchair is shown as Fig. 6 .
Use Buckle
Lock Buckle
Match the waist belt buckle with the shoulder buckle (Fig. 7.1) , and “click”
into the center buckle (Fig. 7.2) , a “click” means the buckle is locked
completely. (Fig. 7.3)
Release Buckle
Press the center button to release the buckle. (Fig. 8)
Adjust Shoulder and waister Harnesses
Note
1. To avoid serious injury from falling or sliding out, always secure your
child with harness.
2. Make sure your child is snugly secured, and that the space between
the child and the shoulder harness is about the thickness of one
hand.
3. DO NOT cross the shoulder belts. This will cause pressure on
child’s neck.
1. The shoulder harness must go into the slot that is even with or
slightly above the shoulders.
2. In order to protect your child from falling out, after your child is
placed into the seat, check whether the shoulder harnesses are at
proper height.
3. For larger child, use the upper shoulder slots. For smaller child, use
the lower shoulder slots.
Note
Choose a pair of proper shoulder slots, thread shoulder harnesses out off
previous slots
(Fig. 9) , and then insert into desired slots in seat pad and seat
back. (Fig. 10) (Fig. 11)
!
When changing shoulder harness slots, make sure shoulder harnesses
are going through same slots in seat pad and seat back.
Use slide adjuster to change the harness length (Fig. 12.1) , press the button
(Fig. 12.2) , while pulling the waist harness to proper length. (Fig. 12.3)
Use Tray
Sliding the tray along the tray bar to a proper position (Fig. 13) while pulling the
button under the tray outward (Fig. 5.1) . The tray has 3 positions for adjust-
ment. (Fig. 14)
!
Ensure both sides of tray are in matching positions.
!
Pull tray backward to ensure both guides are secure.
When the tray is not in use, It can be stored on the rear legs.
Lift the tray from the tray bar, while pulling the button under the tray outward.
(Fig. 5.1)
Place the tray over the rear legs and snap the tray guides into place. It will
automatically slide to the end of the rear legs
(Fig. 15) . The stored tray is
shown as (Fig. 16)
Adjust Recline
There are 3 recline positions. (Fig. 17)
Squeeze button on the back of seat and push down or pull up to adjust the
seat back to a desired recline position.
(Fig. 17.1)
!
It is recommended that the product be used in the upright position only
by children capable of sitting upright unassisted.