Step 9
–
The Roof: Part 1
You will need:
-
2x Upper Roof Panels (10)
-
4x 30mm Screws (A)
Taking the upper roof parts (10), slide them underneath the Roof Ridge (9).
At this point you may need to slacken the screws in the roof ridge to achieve this.
Once both parts meet the inside of the roof ridge you can now securely fasten it (9) down.
Using the pre-drilled holes as a guide, fix the upper roof panels on to the gable ends with screw (A), at each side.
Step 10
–
The Roof: Part 2
You will need:
-
2x Lower Roof Panels (11)
-
4x 30mm Screws (A)
Slide the lower roof panels (11) underneath the upper roof
panels (10) to fit. The narrow edge will tuck under the rebate of
the upper roof panel (10).
Using the pre-drilled holes as a guide, fasten the lower roof
panels on to the gable ends with screw (A), at each side.
You have now completed the assembly of the Head. Now to put the sections together.
These panels have a
rebated edge.
These panels have a flat edge.
